Queen Anne's County, Maryland: Private Well Water Quality
USGS models estimate the private-well arsenic exposure across Queen Anne's County, and USGS laboratory samples from at least 104 wells in the county show measured nitrate, manganese, iron and pH. The arsenic figure is an area estimate; the measurements are of other wells — neither is a test of your own well.
Quick answer: Arsenic is the headline concern for Queen Anne's County well water: USGS modeling estimates about 1,421 residents on private wells with arsenic above the EPA limit of 10 µg/L. Of the 23 Queen Anne's County wells the USGS actually tested for arsenic, 13% were over the limit (median 1 µg/L). The most common measured contaminant in local wells is pH: 45% of 104 sampled wells were outside 6.5–8.5. These figures describe wells across the Maryland county — not your tap — so the only way to know your own water is a certified lab test.
This is a modeled probability for the area, not a measurement of your well. USGS statistical models estimate how many private wells in this area are likely to exceed the federal limit — they cannot tell you what is in your water. Two neighbors can have very different results. The only way to know your well is to test it.
~1,421
people estimated to rely on private wells with modeled arsenic above the 10 µg/L EPA limit
930–2,130
90% confidence range for that estimate
45% of wells
sampled by USGS in the county measured outside 6.5–8.5 for pH (104 wells)
Find out what's actually in your well
Queen Anne's County has one of the higher modeled arsenic exposures in the country — but that number is an area estimate, not your well. Arsenic, nitrate and coliform bacteria are the three most common private-well problems, and none of them has a taste or smell. A certified lab test checks all of them at once; the CDC and EPA recommend testing every well at least once a year.
Basic screening only. Confirm arsenic, nitrate and bacteria with a certified lab.
Find a certified drinking-water labAmazon links are affiliate links — we may earn a commission at no extra cost to you.
Measured well tests in Queen Anne's County
Unlike the arsenic estimate above, these are real laboratory results: the USGS has published chemistry from at least 104 wells in Queen Anne's County, sampled 1988–2016. They describe other wells in the county — domestic, public-supply and monitoring wells — not your well.
| Parameter | Median | Wells over threshold | What the threshold means |
|---|---|---|---|
| Nitrate (as N)33 wells | 0 mg/L90th pct: 9.4 mg/L | 9%Some | > 10 mg/L (EPA MCL). Federal drinking-water limit. Nitrate from fertilizer, manure and septic systems; unsafe for infants and in pregnancy. |
| Manganese73 wells | 34 µg/L90th pct: 295 µg/L | 10%Some | > 300 µg/L (EPA health advisory). Lifetime health advisory; above 50 µg/L it already stains fixtures and tastes metallic. Neurological concern for infants. |
| Iron47 wells | 310 µg/L90th pct: 23,892 µg/L | 51%Elevated | > 300 µg/L (EPA secondary standard). Aesthetic standard — rust-colored staining, metallic taste, clogged fixtures. Not a health limit. |
| pH104 wells | 6.8 90th pct: 8.0 | 45%Elevated | outside 6.5–8.5 (EPA secondary range). Low pH is corrosive and leaches lead and copper from plumbing; high pH causes scale and bitter taste. |
What the samples show
- Nitrate (as N): Nitrate shows up in some wells: 9% of sampled wells were over the limit, and the top 10% reached 9.4 mg/L.
- Manganese: Manganese is common at nuisance levels: 42% of sampled wells were over the 50 µg/L staining standard; 10% over the health advisory.
- Iron: Iron is a common nuisance: 51% of sampled wells exceeded 300 µg/L (median 310 µg/L) — expect rust staining without treatment.
- pH: Groundwater here is acidic: 44% of sampled wells had pH below 6.5 (median 6.8), which corrodes pipes and can leach lead and copper.
- Arsenic (measured, 23 wells): Arsenic was measured above the limit in 13% of sampled wells (median 1 µg/L).
What to do about the biggest finding (pH): Test pH and first-draw lead and copper; a calcite or soda-ash neutralizer corrects acidic water and protects your plumbing. Read more: Lead from corroded plumbing.
Source: USGS well samples aggregated to Queen Anne's County, Maryland — manganese, pH and arsenic from USGS ScienceBase 5f36baa782cee144fb3873e8 (site medians, 1988–2019); nitrate and iron from McMahon et al. (2019), Environ. Sci. Technol. 53:29–38 (NWIS wells). County assignment by Census 2020 boundaries. Statistics shown only where ≥ 5 wells were sampled. USGS well samples; not a test of your well.
Arsenic in Queen Anne's County drinking water: what the estimate means
Arsenic occurs naturally in bedrock and can dissolve into groundwater, so it shows up in private wells with no color, taste or smell. The USGS estimate above combines a statistical model of arsenic probability with the number of people on domestic wells in Queen Anne's County. A higher number means more of your neighbors are likely drinking water over the federal limit — but your own well could be higher or lower. Long-term arsenic exposure is linked to skin, bladder and lung cancers, so the EPA sets the limit at 10 µg/L.
Because arsenic is tasteless and invisible, a certified lab test is the only way to detect it — and unlike bacteria, boiling does not remove arsenic (it slightly concentrates it as water evaporates). A lab reports total arsenic; if yours is elevated, reverse osmosis or an adsorptive arsenic filter reduces it, while carbon pitchers and water softeners do not.
Statewide, Maryland also has a modeled nitrate exceedance of 6% of private-well residents — worth testing for at the same time.
What to do
- Test your well for arsenic, nitrate, manganese and iron — it's the only way to know your actual level.
- If arsenic or nitrate is present, install a reverse-osmosis system — carbon pitchers do not remove either.
- For manganese or iron staining, a whole-house oxidizing filter or softener is the fix; RO for the drinking tap.
- Re-test annually; well chemistry changes over time.
Queen Anne's County well water: frequently asked questions
Is there arsenic in Queen Anne's County drinking water?
Arsenic occurs naturally in the bedrock under Queen Anne's County, Maryland, and dissolves into some private wells with no color, taste or smell. USGS modeling estimates about 1,421 residents (range 930–2,130) on private wells with arsenic above the EPA limit of 10 µg/L. USGS also sampled 23 wells in the county for arsenic directly: the median was 1 µg/L and 13% were over the limit. These are area and other-well figures, not a test of your own well — the only way to know your arsenic level is a certified lab test of your tap.
Queen Anne's County, MD water contamination: what have well tests found?
USGS laboratory samples from at least 104 wells in Queen Anne's County (1988–2016) measured: nitrate 9% of 33 wells > 10 mg/L; arsenic 13% of 23 wells > 10 µg/L; manganese 10% of 73 wells > 300 µg/L; iron 51% of 47 wells > 300 µg/L; pH 45% of 104 wells outside 6.5–8.5. The biggest measured issue is pH. These are tests of other wells in the county, not a public water system report — private wells are unregulated, so your own well needs its own lab test for arsenic, nitrate, manganese and iron.
Are domestic wells in Queen Anne's County, MD acidic — do I need an acid neutralizer?
Acidic water is common in Queen Anne's County domestic wells: 44% of the 104 wells the USGS sampled (1988–2016) had pH below 6.5, with a median pH of 6.8. Acidic water corrodes copper plumbing (blue-green stains, pinhole leaks) and can dissolve lead and copper into your tap water. You only need a neutralizer if your own well tests below about 6.5: a calcite (or calcite/Corosex) tank handles mildly acidic water (roughly pH 6–6.5), while very acidic water usually needs soda-ash injection. Test pH together with first-draw lead and copper.
How do I remove arsenic from Queen Anne's County well water?
Test first so you know your level and form of arsenic. If arsenic is present, a point-of-use reverse-osmosis system under the kitchen sink removes 90%+ of it; carbon pitchers and standard "filter" jugs do not remove arsenic or nitrate. Whole-house treatment (adsorptive arsenic media) is used when the level is high. Re-test after installing and then annually.
Acidic water: neutralize before it corrodes your plumbing
Low-pH well water leaches lead and copper from pipes. A whole-house acid neutralizer is the fix; reverse osmosis at the tap removes any metals already picked up.
Whole-house well water system
Treats every tap, shower and appliance — the right scale for sediment, iron, sulfur and bacteria on a private well.
Compare on Amazon →APEC ROES-50 5-Stage Reverse Osmosis System
5-stage RO, ★ 4.7 — removes arsenic, nitrate, lead, fluoride and PFAS.
Check price on Amazon →Waterdrop reverse-osmosis systems
Under-sink RO removes arsenic, nitrate, lead and PFAS at the kitchen tap.
Shop on Waterdrop direct →Affiliate links — we may earn a commission at no extra cost to you. Re-test after installing to confirm the system is working.