Alabama Private Well Water Risk: Arsenic & Nitrate
These figures are USGS statistical estimates for private (domestic) wells in Alabama. They describe the area's modeled risk — not any single well.
Quick answer: Yes — arsenic occurs naturally in Alabama groundwater. USGS modeling estimates about 2,590 Alabama residents rely on private wells with arsenic above the EPA limit of 10 µg/L. The highest modeled exposure is in Chambers County (~234), Baldwin County (~170), Mobile County (~144). For nitrate, about 0% of Alabama's ~536,000 private-well residents are modeled above the 10 mg/L limit. These are area estimates, not a test of your well — arsenic has no taste or smell, so only a certified lab test tells you your level.
This is a modeled probability for the area, not a measurement of your well. USGS statistical models estimate how many private wells in this area are likely to exceed the federal limit — they cannot tell you what is in your water. Two neighbors can have very different results. The only way to know your well is to test it.
Nitrate
0%
of the private-well population is modeled above the 10 mg/L nitrate limit
~35
people on wells estimated above the limit
~536,000
total residents on private wells statewide
Source: USGS machine-learning nitrate model, Ransom et al. (2022), domestic-well depth zone.
Find out what's actually in your well
USGS models flag arsenic in Alabama, but two wells on the same road can test very differently. Arsenic, nitrate and coliform bacteria are the three most common private-well problems, and none of them has a taste or smell. A certified lab test checks all of them at once; the CDC and EPA recommend testing every well at least once a year.
Basic screening only. Confirm arsenic, nitrate and bacteria with a certified lab.
Find a certified drinking-water labAmazon links are affiliate links — we may earn a commission at no extra cost to you.
Arsenic
Across Alabama, an estimated ~2,590 people rely on private wells with modeled arsenic above the 10 µg/L EPA limit. The highest modeled exposure is in Chambers County (~234 people).
Counties with the highest modeled arsenic exposure
| County | Est. well residents over arsenic limit | 90% range |
|---|---|---|
| Chambers County | ~234 | 151–356 |
| Baldwin County | ~170 | 118–249 |
| Mobile County | ~144 | 99–212 |
| Houston County | ~120 | 87–167 |
| Cleburne County | ~119 | 75–192 |
62 additional Alabama counties have lower modeled arsenic exposure (fewer than 100 estimated well residents over the limit). Of these, 14 have measured USGS well samples: Calhoun, Chilton, Colbert, Elmore, Escambia, Hale, Lamar, Lawrence, Limestone, Macon, Madison, Montgomery, Pickens, Tuscaloosa.
Source: USGS domestic-well arsenic model, Lombard et al. (2021); county population product (2017).
Measured well tests by county
The USGS has published laboratory results from wells in 17 Alabama counties (at least 5 wells each). These are real measurements of other wells — domestic, public-supply and monitoring wells — not a test of yours. The tables rank counties by the share of sampled wells over each federal threshold.
Nitrate (as N): counties with the most wells > 10 mg/L (EPA MCL)
| County | Wells over | Median | Sampled |
|---|---|---|---|
| Tuscaloosa County | 17% | 1.5 mg/L | 6 wells |
| Colbert County | 17% | 3.1 mg/L | 6 wells |
| Macon County | 14% | 0 mg/L | 7 wells |
| Limestone County | 9% | 3.3 mg/L | 11 wells |
| Montgomery County | 3% | 1.5 mg/L | 38 wells |
Manganese: counties with the most wells > 300 µg/L (EPA health advisory)
| County | Wells over | Median | Sampled |
|---|---|---|---|
| Tuscaloosa County | 33% | 202 µg/L | 6 wells |
| Pickens County | 20% | 89 µg/L | 5 wells |
| Macon County | 17% | 86 µg/L | 6 wells |
| Elmore County | 13% | 51 µg/L | 16 wells |
| Limestone County | 10% | 29 µg/L | 10 wells |
| Lawrence County | 9% | 7 µg/L | 11 wells |
| Madison County | 8% | 43 µg/L | 13 wells |
| Montgomery County | 6% | 59 µg/L | 35 wells |
Source: USGS ScienceBase 5f36baa782cee144fb3873e8 (manganese, pH, arsenic) and McMahon et al. (2019), Environ. Sci. Technol. 53:29–38 (nitrate, iron); aggregated by county with Census 2020 boundaries. USGS well samples; not a test of your well.
Acidic well water in Alabama (low pH)
70% of 194 USGS-sampled wells in Alabama had pH below 6.5. Acidic water corrodes copper pipes and fixtures and can leach lead and copper into your tap water — the usual fix is a whole-house acid neutralizer (calcite for mildly acidic water, soda-ash injection for very low pH). Counties with the highest share of acidic wells:
| County | Wells below pH 6.5 | Median pH | Sampled |
|---|---|---|---|
| Tuscaloosa County | 100% | 4.9 | 6 wells |
| Macon County | 100% | 5.9 | 6 wells |
| Baldwin County | 94% | 4.7 | 17 wells |
| Mobile County | 86% | 4.8 | 28 wells |
| Elmore County | 83% | 5.6 | 18 wells |
| Limestone County | 80% | 6.0 | 10 wells |
| Lamar County | 80% | 5.0 | 5 wells |
| Montgomery County | 78% | 5.3 | 49 wells |
| Pickens County | 50% | 6.7 | 6 wells |
| Madison County | 47% | 6.5 | 15 wells |
Source: USGS ScienceBase 5f36baa782cee144fb3873e8 (pH). Measured other wells, not a test of yours.
Match the filter to your test result
Carbon pitchers and faucet filters do not remove arsenic or nitrate. Reverse osmosis is the point-of-use fix; a whole-house system handles the rest of the home.
APEC ROES-50 5-Stage Reverse Osmosis System
5-stage RO, ★ 4.7 — removes arsenic, nitrate, lead, fluoride and PFAS.
Check price on Amazon →Whole-house well water system
Treats every tap, shower and appliance — the right scale for sediment, iron, sulfur and bacteria on a private well.
Compare on Amazon →Waterdrop arsenic-reduction filters
Under-sink units tested for arsenic reduction — the point-of-use fix for a well over the limit.
Shop on Waterdrop direct →Affiliate links — we may earn a commission at no extra cost to you. Re-test after installing to confirm the system is working.
Alabama well water: FAQ
Is there arsenic in well water in Alabama?
Yes. USGS modeling estimates about 2,590 people in Alabama use private wells with arsenic above 10 µg/L, across 67 modeled counties. Arsenic comes from natural bedrock and varies well to well, even between neighbors, so a lab test is the only way to know your own level.
Which Alabama counties have the most arsenic in well water?
By modeled number of well residents over the arsenic limit: Chambers County (~234), Baldwin County (~170), Mobile County (~144). Counties with more private-well users rank higher, so a smaller county can still have a high share of affected wells.
How do I remove arsenic from well water in Alabama?
Test first. If arsenic is present, a point-of-use reverse-osmosis system under the kitchen sink removes 90%+ of it; boiling does not remove arsenic (it concentrates it), and carbon pitchers and water softeners do not remove it either. Whole-house adsorptive arsenic media is used when levels are high. Re-test after installing and then annually.
Is nitrate a problem in Alabama well water?
USGS models about 0% of Alabama's private-well population (~35 people) above the 10 mg/L nitrate limit. Nitrate is highest in shallow wells near fertilized cropland, septic systems or livestock, and matters most for infants and pregnancy.
Do I need an acid neutralizer for my well in Alabama?
Acidic well water is common in Alabama. In USGS lab results from 194 wells across 15 Alabama counties, 70% had pH below 6.5. The most acidic sampled counties are Tuscaloosa County (100% of 6 wells), Macon County (100% of 6 wells), Baldwin County (94% of 17 wells). You only need a neutralizer if your own well tests below about 6.5 — signs include blue-green stains on fixtures and pinhole leaks in copper pipe. A calcite (or calcite/Corosex) neutralizer tank handles mildly acidic water (roughly pH 6–6.5); very acidic water usually needs soda-ash injection. Test first-draw lead and copper too, since acidic water dissolves both from plumbing.
High manganese in Alabama well water — what should I do?
In USGS lab results from 148 wells across 12 Alabama counties, 8% were above the EPA's 300 µg/L health advisory for manganese and 34% were above the 50 µg/L level where it stains fixtures and laundry black or brown. Sampled counties with the highest share over the health advisory: Tuscaloosa County (33% of 6 wells), Pickens County (20% of 5 wells), Macon County (17% of 6 wells). If your own test is over 300 µg/L, don't use the water for infant formula and use another source for drinking and cooking until it is treated — high manganese is linked to neurological effects, especially in babies and children. Boiling does not remove it. For the whole house, an oxidizing filter (greensand, Birm or air-injection) handles manganese, usually alongside iron; a water softener can remove low levels. For drinking water, a point-of-use reverse osmosis system reduces manganese at the kitchen tap. Retest after treatment to confirm it worked.